What are the uses and types of operation of seals?
Release time:
2022-12-07
There are three main types of static seals: gasket seals, sealant seals and direct contact seals.
According to the working pressure, static seals can be divided into low and medium pressure static seals and high pressure static seals. Low and medium pressure static seals are commonly used with soft materials and wide width gaskets, while high pressure static seals are used with hard materials and narrow contact width metal gaskets. Dynamic seals can be divided into two basic types: rotary seals and reciprocating seals. According to the seal and its relative movement of parts whether contact, can be divided into contact seals and non-contact seals; according to the seal and contact position can be divided into circumferential seal and end seal, end seal is also known as mechanical seal. Dynamic seals in the centrifugal seal and spiral seal, with the help of machine operation to the medium with power to get sealed, so sometimes called power seal.
According to the type of sealing structure, sealing mechanism, seal shape and materials, etc., the classification of the seal: packing into the packing cavity, after the gland for it to axial compression (see Figure 29.5-9), when the shaft and packing have relative movement, due to the plasticity of the packing, so that it produces radial force, and close contact with the shaft. At the same time, the lubricant impregnated in the packing is extruded and an oil film is formed between the contact surfaces. As the contact state is not particularly uniform, the contact part will appear "boundary lubrication" state, known as "bearing effect"; and not in contact with the concave part of the formation of a small oil groove, there is a thicker oil film, contact parts and non-contact parts form an irregular labyrinth, play to stop the role of liquid leakage, this is called the "labyrinth effect". This is the mechanism of the packing seal. Obviously, a good seal lies in maintaining the "bearing effect" and the "labyrinth effect". In other words, good lubrication and proper compression should be maintained. If the lubrication is not good, or if the pressure is too tight, the oil film will be interrupted, causing dry friction between the packing and the shaft, eventually leading to burned shafts and serious wear.
For this reason, the degree of packing compression needs to be adjusted frequently so that after a period of loss of lubricant in the packing, some more lubricant is squeezed out and the slack in the packing caused by volume changes is compensated for. Obviously, such frequent squeezing of the filler will eventually deplete the impregnating agent, so regular replacement of the filler is necessary. In addition, it is also necessary to intentionally allow a small amount of leakage at the packing in order to maintain the liquid film and carry away frictional heat.
The valve oil seal (VALVESTEMSEAL) in the seal is generally vulcanised by the outer skeleton and fluoroelastomer, with a self-tightening spring or steel wire at the diameter mouth, and is used for sealing the valve guide rod of the engine, which is a kind of oil seal.
Related News